Owner`s manual

39
At any time while operating in Surface Modes, the ZEN will
enter Dive Mode upon descent to 5 FT (1.5 M).
• During the 2 hour pre dive surface period, if the M button is
pressed/released to access Watch Mode, the DC Surface
Mode must again be accessed prior to the first dive of a
series (if Wet Activation is set OFF).
• When Wet Activation is set ON, the Wet Contacts will
activate the selected Dive Mode regardless of what Mode
the ZEN is operating in at the time of the descent.
The ZEN will enter Post Dive Surface Mode following a dive
upon ascent to 2 FT (0.6 M) for 1 second. The Surface Interval
Time colon will flash during the first 10 minutes after a NORM or
GAUG dive (Fig. 29A), or 1 minute after a FREE dive (Fig. 29B).
During the first 10 minutes after a dive, the Surface Main screen
for that operating mode remains on display. Watch Default Time
can be viewed for 5 seconds during that period by pressing and
releasing the M button momentarily (< 2 sec).
When the 10 minute Surface Time has elapsed, the Watch De-
fault Time screen will replace the DC Surface Main screen which
can then be accessed by pressing the M button for 2 seconds.
Fig. 29B - SURFACE MAIN
(0 min 42 sec after FREE dive)
Fig. 29A - SURFACE MAIN
(2 min after NORM dive)
or
GAU