Manual

BEFORE YOU CALl. FOR SERV|C_
Please check the following before calling for service. It may save you time and expense.
PROBLEM POSSIBLE CAUSE SOLUTION
Part or all of Warming • Power cord of Warming Drawer is not •
Drawer does not operate, completely connected to the electrical
outlet.
Make sure the power cord is tightly connected
to the outlet.
• Check house lights to be sure. Call your local
• Power outage, electric company for service.
• Fuse blown/circuit breaker tripped. • Replace the fuse or reset the circuit breaker.
2 Food in Warming Drawer is • No power to the appliance. • See SOLUTION for PROBLEM 1.
not heated. • Drawer controls improperly set. • Check if the controls have been properly
set.
3 Warming Drawer light does • Light bulb is loose or burned out. • Call for service.
not work.
4 Touch controls will not • Power cord of Warming Drawer is not • Make sure the power cord is tightly connected
operate, completely connected to the electrical to the outlet.
outlet.
• Check house lights to be sure. Call your local
• Power outage, electric company for service.
• Fuse blown/circuit breaker tripped. • Replace the fuse or reset the circuit breaker.
5 Power light oft. • Power failure. • If the Warming Drawer was in use, you must
reset the heating function.
6 Drawer does not slide • Ball bearings are out of alignment. • Fully extend the drawer and push it all the way
smoothly or drags. • Drawer over-loaded or load unbalanced, in. See the Care and Cleaning section.
• Drawer not replacedproperly after removal. " Reduce weight to less than 50 pounds.
Redistribute drawer contents.
• Remove drawer and replace again.
7 Excessive condensation.
• Liquid in Warming Drawer.
• Uncovered foods.
• Temperature setting too high.
• Incorrect Humidity setting.
• Remove liquid.
• Cover food with lid or aluminum foil. DO
NOT use aluminum foil to line any part of
the Warming Drawer.
• Reduce temperature setting.
• Set the Variable Humidity Control to the open
vent setting to allow venting.
8 No heat in the proof setting. • Roomtemperature maypreventthe thermostat . Press TEMP to select LOW and then select
from tripping on. PROOF.
9 Food dries out. • Moisture escaping. • Cover food with lid or aluminum foil. DO
NOT use aluminum foil to line any part of
the Warming Drawer.
• Set the Variable Humidity Control to the
closed vent settings to prevent venting.
11