RESU 3.3, 6.5, 10, RESU Plus

3 Installation Prerequisites
3.1 Installation materials
These installation materials shall be prepared by installers.
• Charging cable
• Network cable
• Ground wire
• RJ45 plug
• Silicone sealant or putty
NOTICE
Make sure that the cross-sectional area of charging cables is 33 to 50 mm
2
.
3.2 Installation location
Make sure that the installation location meets the following conditions:
• The building is designed to withstand earthquakes.
• The location is far away from the sea, to avoid salt water and humidity.
• The oor is at and level.
• There are no ammable or explosive materials nearby.
• The optimal ambient temperature is between 15 and 30°C.
• The temperature and humidity stays at a constant level.
• There is minimal dust and dirt in the area.
• There are no corrosive gases present, including ammonia and acid vapor.
NOTICE
The RESU battery pack is rated at IP55 and thus can be installed outdoors as well
as indoors. However, if installed outdoors, do not allow the battery pack to be
exposed to direct sunlight and moisture.
NOTICE
If the ambient temperature is outside the operating range, the battery pack stops
operating to protect itself. The optimal temperature range for the battery pack to
16