RESU 3.3, 6.5, 10, RESU Plus
Table Of Contents
- Contents
- 1 Safety
- 2 Product Introduction
- 3 Installation Prerequisites
- 4 Battery Pack Installation
- 5 RESU Plus Installation
- 6 Configuration Switches
- 7 Commissioning
- 8 Troubleshooting
- 9 Firmware Update
- 10 Warranty
- 11 Certifications
- A Compatible Inverters
- B Supported Memory Cards
Battery Pack Installation
NOTICE
Pay attention not to reverse polarity. Connection with reversed polarity causes se-
vere damage to the battery pack.
ON
O
FF
C
ONNE
C
T
ION K
IT
2. Connect the charging cables to the terminal
block.
a) Remove the terminal cover plate, which is
placed over the terminal block to protect
it.
b) Connect the negative cable (−) to the ter-
minal on the left and the positive cable (+)
to the one on the right. Tighten the hex-
socket screws to a torque of 6 N·m.
c) Place the cover back on top.
3. Push the grommets into the cable entries.
4.8 Finalizing installation
O
N
O
FF
C
ONNECT
IO
N
K
IT
Follow these steps to nalize the installation.
1. Stu the small grommets left unused with an insulating material like silicone
sealant, and then push them into the remaining holes.
2. Apply silicone sealant or putty around the cable at each grommet to prevent for-
eign materials from entering the battery pack.
3. Check if the conguration switches are set properly, referring to Conguring Bat-
tery pack on page 39.
30