RESU 3.3, 6.5, 10, RESU Plus
Table Of Contents
- Contents
- 1 Safety
- 2 Product Introduction
- 3 Installation Prerequisites
- 4 Battery Pack Installation
- 5 RESU Plus Installation
- 6 Configuration Switches
- 7 Commissioning
- 8 Troubleshooting
- 9 Firmware Update
- 10 Warranty
- 11 Certifications
- A Compatible Inverters
- B Supported Memory Cards
RESU Plus Installation
3. Pull up the circuit board to remove it.
NOTICE
To prevent the circuit board from being damaged or soiled, keep it in a safe place
until it is replaced.
4. Determine where the anchor bolts are to be
placed.
5. Drill holes in the wall for the M8 (0.3 in) an-
chor bolts. The drilling depth should be 50
mm at least.
6. Drive the anchor bolts into the wall holes
through the screw holes at the upper left and
the lower right of the rear of the RESU Plus.
7. Tighten the anchor bolts to a torque of 8 N·m.
5.4 Cable connections
WARNING
Before connecting cables to the RESU Plus, make sure that the inverter and battery
packs are turned o.
34