Operation Manual, User's Manual

1-97
BEFORE USING THE MACHINE►LOADING PAPER
LOADING PAPER INTO THE BYPASS TRAY
Use the bypass tray for printing on plain paper, envelopes, label sheets, and other special media.
Up to 100 sheets of paper can be loaded (Heavy paper weighing betwee
n 106 g/m
2
to 220 g/m
2
(28 lbs. cover to 80 lbs.
index): 40 sheets, 221 g/m
2
to 256 g/m
2
(80 lbs. cover to 140 lbs. index): 20 sheets, and envelope, transparency film: 20
sheets) for continuous printing, just like operation using other trays.
How to place the original
Load paper in landscape orientation.
Inserting transparency film
When using plain paper other than Sharp standard paper or special media other than SHARP-recommended transparency
film, glossy paper, or when printing on the reverse side of paper that has been printed on one side, load paper one sheet
at a time. Loading more than one sheet at a time will cause misfeeds.
Before loading paper, straighten any curling in the paper.
To add paper, press down the pressure plate until it locks, remove any paper remaining in the bypass tray, combine it with
the paper to be added, and place in the bypass tray again. If paper is added without removing the remaining paper, a
misfeed may result. Loading more sheets than the specified number of sheets or the limit may cause paper misfeeds.
After loading paper in the bypass tray, always check the paper type and size.
Use SHARP-recommended transparency film.
When loading multiple sheets of transparency film into the bypass tray, fan the sheets several times before loading.
When printing on transparency film, remove each sheet of film as it is printed. If multiple sheets of film are allowed to stack
on the output tray, the sheets may stick together or become curled.