User Manual

7-14
SYSTEM SETTINGS►SETTING MODE LIST
Image Send Settings
Common Settings
U: General user; A: System administrator/Administrator
Setup Items Factory default setting U A
● Common Settings (page 7-120)
X Condition Settings No Yes
 Hold settings for a while after scanning has been
completed
Disabled
No Yes
 Job Auto Start Time During Scanning 60sec.
 Default Display Setting E-mail (Fax when the facsimile
expansion kit is installed)
No Yes
 Address Book Default Selection No Yes
• Higher priority is given to the display of address
book.
Disabled
No Yes
• Apply Addresses of Sending Modes Only Enabled No Yes
 Category Displayed as Default None No Yes
 Display all address type regardless of the mode being
displayed currently.
Disabled
No Yes
 Enlarge Address Book Enabled No Yes
 Image Orientation Portrait No Yes
 Preview Setting No Yes
• Received Data Image Check Setting Disabled No Yes
• Default List/Thumbnail Display No Yes
- Fax/I-Fax Reception Data*
1, *2
Thumbnail No Yes
 Default Exposure Settings Auto No Yes
 Default Original Image Type Text No Yes
 Sending the same image sent in Fax mode*
1
Disabled No Yes
 Be sure to press Next Address Key ([+]) before
selecting the next address.
Disabled
No Yes
 Scan Complete Sound Setting Middle No Yes
 Disable Switching of Display Order Disabled No Yes
 Hold Setting for Received Data Print Disabled No Yes
 Default Verification Stamp
*3
No Yes
• E-mail/Scan/Data Entry Disabled No Yes
• Fax/Internet Fax
*1, *2
Disabled No Yes
 Erase Width Adjustment No Yes
• Edge Clearance Width 10mm (1/2") No Yes
• Centre Clearance Width 10mm (1/2") No Yes
 Time Specified Output of Received Data Disabled No Yes
X Enable/Disable Settings No Yes