User Manual

7-83
SYSTEM SETTINGS►SYSTEM SETTINGS
Copy Settings
Condition Settings
The following settings are related to copying.
Default settings selected with these settings apply to all functions of the machine (not just the copy function).
Rotation Copy Setting
When the original and paper are placed in different orientations, this function automatically rotates the image 90 degrees
to enable correct copying on the paper.
Add or Change Extra Preset Ratios
Add two enlargement preset ratio values (101% to 400%) and two reduction preset ratio values (25% to 99%).
Also, you can change the preset ratio if necessary.
Setting a Maximum Number of Copies
This is used to set the maximum number that can be entered for the number of copies (number of continuous copies).
Any number from 1 to 9999 can be specified.
Initial Margin Shift Setting
This is used to set the default margin shift amount. Specify a value from 0 mm (0") to 50 mm (2") in increments of 3 mm
(1/8" ) for both the front and reverse sides.
Erase Width Adjustment
This is used to set the default erase width for erase function. Specify a value from 0 mm (0") to 25 mm (1") in increments
of 3 mm (1/8") for both edge erase and centre erase.
InitialN-Up Setting
Set the default state for N-Up. Select the page layout for N-Up, whether or not borders are added, and if added, whether
the borders are solid lines or dotted lines.
Card Shot Settings
This is used to set the default original size for the card shot function.
Specify a value from 25 mm (1") to 216 mm (8-1/2") in increments of 3 mm (1/8") for both the X (horizontal) and Y
(vertical) dimensions of the original.
Fit to Page
Enable this setting to have the [Fit to Page] key always appear in the card shot screen.
Enable the Rotation Copy setting to copy an A5 (5-1/2" x 8-1/2") size original on A5R (5-1/2" x 8-1/2"R) paper.
Preset ratios other than added preset ratios cannot be changed.