Operation Manual

1-31
BEFORE USING THE MACHINEBEFORE USING THE MACHINE
MOTION SENSOR (MX-3070N/MX-3570N/MX-4070N/
MX-5070N/MX-6070N only)
This sensor detects the presence of a person that approaches the machine, and automatically wakes the machine from
sleep mode (Motion Sensor Mode Only).
Three settings are available for the detection range ( / / ).
When a finisher (large stacker) or saddle stitch finisher (large stacker) is installed on the MX-5070N/MX-6070N, open the
front cover on the finisher (large stacker), or the front upper cover on the saddle stitch finisher (large stacker), before
opening the front cover of the machine.
The motion sensor detects the movement of sources of heat.
The detection range may vary depending on the installation site and environment (ambient temperature, etc.).
The motion sensor may not operate correctly in the conditions below.
An object is in front of the motion sensor
There are scratches or dirt on the motion sensor cover
The motion sensor is directly exposed to sunlight or air flow
The motion sensor is damaged
There is a source of heat such as a heater nearby
An object is moving in the detection range
To enable the motion sensor
"Settings (administrator)" select [System Settings] [Energy Save] [Eco Setting] [Sleep Mode Power Level].
Motion sensor
Near Far
Detection range
Approx.
maximum
1.5 m
60 degrees