Operation Manual

Contents
1. Part Names
2. Basic Operation
3. Menu Operation
4. USB Media
5. Connecting Other
Devices
6. Operating the Monitor
Using a PC (IP control)
7. Troubleshooting
1. If You Suspect a
Problem
9. If Error Message
Appears
11. What If
8. Specifications, etc.
You can select a language.
English >>
Français >>
Español >>
Deutsch >>
Ver. 1.00
＞
＜
Troubleshooting
If You Suspect a Problem
General
What if Where to check Reference page
Video appears on Monitor but no sound comes out of it
Is the volume control set to the minimum level? 2-2
Is it set to "Mute"? ―
Is the headphone left plugged into the headphone terminal? 1-2
The audio sound differs in volume level from one input
source to another
Because the input sound level may vary depending on the device connected or the disk played back, the volume can be set
per input. Set the volume control for each input.
2-2
Video image from a BD player or external device does
not appear, or stopped appearing, on the Monitor
Is the external device unplugged? ―
Is the external device turned on? ―
Have you selected the input to which the external device is connected? 5-16 to 5-17
For INPUT 5 or INPUT 6, due to the provisions of Advanced Access Content System (AACS), BD videos (commercial blue-
ray software) from certain external devices connected to the INPUT cannot be played back on the Monitor.
―
Due to copyright restrictions, videos from certain devices fail to appear on Monitor unless the devices are directly connected
to the Monitor through HDMI cable.
―
Sound comes out of the
Monitor but no video
appears on it
Is Audio only set to "On"? 3-24
Is the video cable disconnected? 5-12
Faded
poorly tinted
Are "Color" and "Tint" for video picture properly adjusted? 3-10
Due to the viewing angle characteristics of the LC panel, when viewed from an oblique direction, some video pictures may
look faded or have a different color tone. This is not a failure.
―
7-4
5/27/2020 Sharp operation manual