Owner`s manual
• Increase of floppy
'disk
interface-
ROM
•
Floppy
disk
drive
control
ROM
If
the DISK BASIC controls the floppy disk drive (MZ-1F02), connect the ROM chip
(see below) which
is
packed together with the DISK BASIC to the socket of the
floppy disk interface
(MZ-IEOS: optional).
If
this ROM
is
not connected to the floppy
disk interface, the floppy disk drive cannot be controlled.
Note the following points when connecting the
ROM to the interface:
• Take care not to drop, scratch or otherwise damage the ROM. Do not expose it to
a strong magnetic field.
• Take special care not to break
or
bend the pins of the ROM.
•
Before pressing the ROM into the socket, be sure that its pins are correctly aligned
with the socket holes.
Be sure that the notches in the
ROM and socket match each other before pressing
the
ROM in.
Do not remove the seal attached to the
ROM.
•
Do not touch the pin of the ROM, because static electricity may destroy the ROM
contents.
Seal
N_-ctn