Specifications

6
6-4
Memory module
Edge connector
on module
Edge connector slot
6. After the module is inserted into the slot, press it down flat into the compartment
so that the spring latches inside the compartment grip the edges of the memory
module and hold it in place.
7. If you are removing an old module, press these same spring latches apart so that
the memory module pops out of the compartment and then pull the edge
connector of the module free from the edge connector slot.
8. Replace the compartment cover and secure it with the two screws.
9. When you restart your computer, press the
Esc
key or the
F2
key when you see
the Sharp logo and setup prompt. You can verify that the new memory is
installed and functional by checking how much System RAM is displayed on the
Diagnostic screen or on the
Main
page of the setup utility.