Specifications

7-3
7
Password Requirements
If you have enabled
Password on boot
in the
Security
page of the setup utility, the
system will ask for a password when the system is started. If a user password is
entered, then the user has limited access to the floppy disk drive as set by holder of
the supervisor password.
When the setup utility is opened, a password is required. If a user password is
entered, the user does not get access to the
Advanced
page of the setup utility. On the
Security
page of the setup utility, the user cannot get access to the
Set Supervisor
Password
, the
Password on boot
, or the
Diskette access
items.
Setting a Password for Standby/suspend Resume
Use the Windows
Power Management Properties
program to set a password that
must be entered in order to resume the system from a standby/suspend-to-RAM
mode. If you have already installed a Windows password you can skip steps 1-4.
1. From the
Start
menu, select
Settings
-
Control Panel
.
2. In the
Control Panel
, click on the
Passwords
icon to open the
Passwords
Properties
windows.
3. Use the
Change Passwords
tab to install a password for windows.
4. You need to restart your computer to complete the password installation.
5. Return to the
Control Panel
. Double-click the
Power Management
icon to open
the
Power Management Properties
window.
6. Click on the
Advanced
tab. Check the box marked
Prompt for password when
computer goes off standby
.