Installation Manual

PAGE 6
INSTALLATION INSTRUCTIONS
SHORT THROW PROJECTOR WALL
MOUNTING BRACKET AN-STWM20
STEP 3. HANG THE PROJECTOR
3.1 Hang the projector on the long inner slide tube by sliding the rectangular sleeve over the long tube.
3.2 Slide the sleeve forward over the long tube to the desired position and secure it with the two knobs on
either side of the sleeve.
3.4 Insert the stop onto the end of the long tube and secure with the 1/4-20x5/16” screw provided.
STEP 4. ATTACH ALL CABLES AND POWER CORD
4. Tuck all the wires into the zig-zag slot on the topside of the long tube.
STEP 5. FINAL POSITIONING ADJUSTMENTS.
5.1 Slide the projector assembly along the tube to
adjust the size of the image on the screen.
5.2 Loosen screw “A” FIG. 6, to adjust and set
vertical positioning, tighten screw
5.3 Loosen Screw “B” to adjust horizontal tilt and
tighten screw.
5.3 Use the four mounting screws and slots
to adjust horizontal positioning and tighten screws.
SPECIAL NOTE: IN THE EVENT YOU WANT TO MOUNT
THE PROJECTOR CLOSER TO THE WALL THAN THE LONG
TUBE WILL ALLOW, YOU CAN REMOVE THE SCREWS FROM THE FAR END OF THE UPPER
SUPPORT BRACKET AND SLIDE THE SLEEVE ON THE TOP OF THE PROJECTOR MOUNTING
ASSEMBLY ON TO THE OUTER TUBE. (THE RECTANGULAR SLEEVE IS LARGE ENOUGH TO
ACCOMMODATE THIS). RE-INSTALL THE SCREWS AND POSITION THE PROJECTOR TO THE
DESIRED CLOSER LOCATION.
FIG. 6
2.5 Tighten the button head screws on both sides of the extension tube after you have set the desired length.
See Figure 5.