Troubleshooting guide


TOXIC FLUID HAZARD
Hazardous
fluids or toxic fumes can cause serious injury or death if splashed in the eyes or on the
skin, inhaled, or swallowed.
Know the specific hazards of the fluid you are using.
Store hazardous fluid in an approved container
. Dispose of hazardous fluid according to all local,
state and national guidelines.
Always wear protective eyewear
, gloves, clothing and respirator as recommended by the fluid
and solvent manufacturer
.
FLUID INJECTION HAZARD
Spray
from the dispensing valve, leaks or ruptured components can inject fluid into your body and
cause extremely serious injury
, including the need for amputation. Fluid splashed in the eyes or on
the skin can also cause serious injury
.
If a fluid injection injury occurs, get
emergency medical care at once. Do not treat as a simple
cut. T
ell the doctor exactly what fluid was injected.
NOTE T
O PHYSICIAN:
Injection into the skin is a traumatic injury
.
It is important to treat the
injury surgically as soon as possible.
Do not delay treatment to research toxicity
. T
oxicity is a
concern with some exotic coatings injected directly into the blood stream. Consultation with a
plastic surgeon or reconstructive hand surgeon may be advisable.
Do not point the dispensing valve at anyone or at any part of the body
.
Do not put your hand or fingers over the end of the dispensing valve.
Do not stop or deflect leaks with your hand, body
, glove or rag.
Use only extensions and no-drip tips which are designed for use with your dispensing valve.
Do not use a low pressure flexible nozzle with this equipment.
Follow the
Pressure Relief Procedure
on page 9 if the grease fitting coupler clogs and before
cleaning, checking or servicing the equipment.
T
ighten all fluid connections before operating the equipment.
Check the hoses, tubes, and couplings daily
. Replace worn or damaged parts immediately
. Do
not repair high pressure couplings; you must replace the entire hose.
Fluid hoses must have spring guards on both ends, to help protect them from rupture caused by
kinks or bends near the couplings.
WARNING
WARNING