Manualshelf

Installation Guide

ManualsBrandsSharp ManualsOver-the-Range MicrowavesSharp Carousel 1.1 Cu. Ft. 850W Stainless Steel Over-The-Range Convection Microwave Oven
12345678
6
10 OVEN INSTALLATION
THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUCTIONS FOUND ON
BOTH TEMPLATES.
READ AND FOLLOW MOUNTING INFORMATION ON BOTH TOP CABINET AND WALL TEMPLATES.
MOUNTING SCALE PLATE
1. Separate 4 Toggle Bolts 2, packed in the INSTALLATION HARDWARE, from the Toggle Nuts.
2. Use Wood Screws 1to attach Mounting Plate to the stud or studs. Use Toggle Bolts to attach Mounting Plate through the holes
at A, B, C and D; UNLESS THOSE HOLES ARE LOCATED ON THE STUD. Insert one Toggle Bolt into A, B, C and D where
appropriate (these correspond to the holes of the Wall Template) and put the Toggle Nuts onto the Toggle Bolts. Figure 18.
Refer to instructions in Wall Template.
3. Position the Mounting Plate with the Toggle Bolts attached at the wall location and insert Toggle Nuts and Bolts through the
holes in the wall with the Toggle Nuts closed. Figure 19. Use Wood Screws 1 to attach the Mounting Plate to studs.
NOTE:
Before insertion, be sure you leave a space more than the thickness of the wall between the Mounting Plate and the
end of each of the Toggle Nuts (in the closed position). If you do not leave enough space, the Toggle Nut will not be able to
open on the other side of the wall. Also, once a Toggle Nut opens, it cannot be withdrawn from the hole; therefore make sure
all of the Toggles are in the correct position before insertion.
4. Align the Mounting Plate carefully and hold in position while tightening Toggle Bolts. Pull Toggle Bolt toward you and turn
clockwise to tighten. Figure 20.
Mounting
Plate
Figure 18 Figure 19 Figure 20
Space more than
wall thickness
Wall
MOUNTING OVEN TO THE WALL
Note: Does not apply to R-1881LSY
Two people are recommended to attach the Microwave Oven/Hood to the
Mounting Plate.
1. Place cut portion of carton (B) on top surface of range. Protection of the
range cooking surface is recommended. A protective drop cloth may also
be used to cover the top of the range.
2. Place carton portion (C) on portion (A); then place oven as shown in
Figure 21.
3. Place the oven and the carton portions together on the top of the range
covered with (B). Slide carton portion (A) toward backsplash until stops.
Align the lower back edge of the oven with the mounting plate.
(A)
(C)
Figure 21