Installation Guide

7
4. Thread the power supply cord through the hole made in the bottom of the
top cabinet.
5. Hang the oven on the lower edge of the mounting plate. Rotate the unit
upward. See Figure 22. Take care that the power cord is able to clear
the edge of the hole as the oven is rotated upward. (In the case of a
non-recessed bottom in the top cabinet, the hole for the cord may need
to be enlarged.) Remove the carton portions.
6. Tighten the two unit mounting screws located in the grease lter openings.
See Figure 23.
7. Install grease lters by tting into the opening. Push back and up into
place. See Figure 24.
8. Use the two Top Cabinet Screws (D) and two Flat Washers (E), supplied
in the INSTALLATION HARDWARE, to attach the unit to the top cabinet.
See Figure 25.
9. Make a bundle of the power supply cord and place it inside the cabinet.
(A)
Hang at
these
locations
Figure 22
Figure 23
Unit
mounting
screw
Figure 24
Grease filter
Figure 25
(D)
Grommet
(for metal
cabinet only)
(E)