Manualshelf

Instructions / Assembly

ManualsBrandsSharp ManualsAppliance parts27 in. Trim Kit for Sharp SMC1842CS and SMC1843CM Microwave Ovens in Stainless Steel
1234
2
The opening in the wall or cabinet must be within the
following dimensions:
Cut Out RK49S27 RK49S30
Height (A) 14
1
/2" to 15
3
/4" 14
1
/2" to 15
3
/4"
Width (B) 24
11
/16" to 25
5
/16" 24
13
/16" to 26
3
/4"
Minimum
Depth (C)
20" 20"
Outlet should NOT be in the shaded area as indicated on
Sketch 1.
A
B
4"
C
4"
SKETCH 1
NOTES
• Please allow minimum 3" wood gap between the
microwave oven cutout and the appliance cutout below
the microwave oven. See Sketch 2
3" Min.
Microwave cutout
Wall oven cutout
SKETCH 2
• If the dimension of DEPTH (C) is more than 21", the outlet
location may be any area on the rear wall.
• The oor of the opening should be constructed of plywood
strong enough to support the weight of the oven and oor
load (about 100 pounds). The oor should be level and
90˚ with the face of the cabinet for proper installation and
operation of the oven. Be sure to check the local building
code as it may require that the opening be enclosed with
sides, ceiling and rear partition. The proper functioning of
the oven does not require the enclosure.
STEP 1 CABINET OR WALL OPENING