RK94S27F, RK94S30F Installation Manual

E 7
FLUSH INSTALLATION INSTRUCTIONS
STEP 4 - FRAME INSTALLATION
A. Place the oven adjacent to the wall or cabinet opening.
Plug the power cord into the electrical outlet.
B. Carefully guide the assembled oven into the prepared
opening. Slide the oven onto the Exhaust Duct Assembly.
See Figure 8. Avoid pinching the cord between the oven
and the wall. Adjust the position of the oven so that the
feet of the oven are tted into the recesses of the Exhaust
Duct Assembly and the door opens properly. See Figure 9.
Screw D
Screw D
FIGURE 8
Exhaust
duct
assembly
Foot
Duct recess
FIGURE 9
C. DISASSEMBLY: The FRONT FRAME and BACK FRAME
come pre-assembled with ball studs engaged in the
receivers. Separate the FRONT FRAME from the BACK
FRAME. Place the assembly facedown onto a protected
surface. At the location of the ball stud, insert a athead
screwdriver between the FRONT FRAME and the BACK
FRAME and gently pry up to disengage the ball stud from
the receiver. Repeat for each corner. See Figure 10.
FIGURE 10
D. BACK FRAME INSTALLATION: Position BACK FRAME
equal space top to bottom, side to side. Mark for 4 holes
on the installed wood cleats, center punch and pre-drill
with
1
16drill bit. Secure frame with 4 SCREWS (G). See
Figure 11.
Equal gap top, bottom
Equal gap
side to side
Mounting holes
Mounting holes
Mounting holes
Mounting holes
Screw G
Screw G
Screw G
Screw G
FIGURE 11