Service manual

SJ-40J-GY/ BE
SJ-W40J-GY/ BE
SJ-36J-GY/ BE
SJ-W36J-GY/ BE
11
(4) Check the balance of the door opening force, self-
closing force and roller climbing width between the
left and right sides.
• Referring to the right figure, check the climbing
width.
When the balance is poor between the left and right
sides, proceed with the following work.
(5) Adjust the upper hinge. (Because the position
relationship of the door and hinge varies at the upper
area of the door in Item (3)-1.)
(b) Lightly press the door, relocate the upper hinge
toward you, and tighten the screw.
(a) Loosen the screws (6 pieces) on the hinge, and
swing the door forward and backward approx.
5 times. (Snugly fit the hinge to the door.)
Figure F-13
Figure F-14
Figure F-15
Figure F-16
Figure F-17
Figure F-18
Table support
Upper hinge
T hinge SPA05
(0.5 mm thick on the
left and right sides
as symmetric)
R & L door
Door cam upper
2 mm or less
Upper hinge
• Check the clearance between the upper hinge
and Door cam upper. If it is rubbed during opening/
closing, insert the spacer (T hinge SPA05) under
the table support.)
(Insert plural spacers according to the adjustment
width.)
R & L door
Door cam bottom
0.5 to 1 mm
(both left and right sides)
Lower hinge
ass'y
Hinge pin
Top hinge cover
Table support
Table support
Determine the position
with the screws.
Relocate the upper
hinge toward you.
Lightly press here.
Upper hinge
12.5 ±1mm
Upper hinge
Swing the door
forward and backward
approx. 5 times.
[Details of service parts]
1. Spacer assembly
2. Silicon oil
1 Part code:
CSOG-C803CBK0
2 Part code:
FPAK-A275CBE0
Roller spacer Door cam spacer T hinge SPA05Components:
Two pieces per each pack.
(They are all 0.5 mm thick.)
*
*