Service manual

SJ-40J-GY/ BE
SJ-W40J-GY/ BE
SJ-36J-GY/ BE
SJ-W36J-GY/ BE
15
Figure A-5
7. Stick V-heater on Center insulation a.
Stick A sealer rf b on Center insulation a.
(Figure A-6)
F-thermo capi. tube
Lead wire
f box
W-sealer
rf c
4. Form capillary tube of F-thermostat as shown
Figure A-3, hook each side the claw of C-partition f.
(Figure A-4)
5. Form the end of capillary tube of F-thermostat and fix
with claw as shown. (Figure A-4 or Figure A-5)
6. Stick W-sealer rf c . (Figure A-5 )
Figure A-4
8. Set Center insulation a on C-partition f. (Figure A-7 )
9. Wiring Lead wire f box on Center insulation a.
10. Set the “8” ass’y on C-partition r and fix with claws.
Fix by tapping screw.
11. Stick W-sealer fr a and Drain sealer a and Corner
sealer R&L on outside of “10” ass’y.
(Figure A-4,A-7 )
Figure A-7
C partition f
Center
insulation a
C -patition r
SEC. B
A sealer rf c
W sealer fr a
A sealer rf b
Center insulation a
A sealer rf b
V heater
Paper tape
5mm
Figure A-6
C-partition f
F-thermostat
A sealer rf c
Tapping screw
B
Corner sealer l
Corner sealer r