manual

5
WARNING
Do not install the refrigerator in a damp or wet location ■
as this may cause damage to the insulation and a
leakage. Condensation may also build on the outer
cabinet and cause rust.
1
Keep adequate ventilation space around the refrigerator.
The gure shows the minimum required space for installing •
the refrigerator. The measurement condition of power
consumption is conducted under a different space dimension.
By keeping greater space, the refrigerator may be •
operated under a less amount of power consumption.
If using the refrigerator in the smaller space dimension •
than the below gure, it may cause the temperature rise
in the unit, loud noise and failure.
2
Use the two front adjustable feet, to ensure that the
refrigerator is positioned rmly and at on the oor.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
INSTALLATION
90mm
or more
60mm
or more
60mm
or more
1180 mm
1500 mm
60mm or more
3
When right and left doors are not properly aligned, adjust
using the adjustable feet.
NOTE
Position your refrigerator so that the plug is accessible.•
Keep your refrigerator out of direct sunlight.•
Do not place next to heat generating appliance.•
Do not place directly on the ground. Provide suitable stand. •
To insert the power plug when the door is opened, door alarm •
sounds but it is not abnormal. This sound stops when closing the
door.
Adjustable foot
When the left door
is raised.
When the right door
is raised.
Lower the foot
at right side.
Lower the foot
at left side.
(Until the adjustable foot on the
other side is slightly off-ground.)
4
Remove the 4 screws of the cabinet lower part, and then set
the foot cover (supplied inside the refrigerator compartment)
with removed 4 screws.
Screw
(4 screws)
Screw
Foot cover
Free standing type
This refrigerator is provided with an indicator of temperature in the refrigerator compartment to allow you to control the average
temperature in the coldest zone.
Coldest zone
The symbol indicates the coldest zone in the
refrigerator compartment.
(The door pocket positioned at the same height isn't
the coldest zone.)
Checking the temperature in the coldest zone
You can carry out regular checks to ensure the temperature
in the coldest zone is correct and, if necessary, adjust the
refrigerator temp. control.
To maintain a correct temperature inside the appliance, check
that the indicator of temperature is always BLUE.
If the indicator of temperature turns WHITE, the temperature
is too high; in this case, increase the refrigerator temp. control
setting and wait for 6 hours before checking the indicator of
temperature again.
NOTE
The internal temperature of the refrigerator depends on various •
factors such as the ambient temperature of the room, the amount
of food stored and the frequency of door opening.
When fresh food has been introduced or the door has been left •
open for some time, it is normal for the indicator of temperature to
turn WHITE.
BLUE
WHITE
Correct setting Temperature too high,
adjust the refrigerator temp.
control.
Symbol
INDICATOR OF TEMPERATURE
(B325)W.indb 5 2012/05/30 13:28:09