Technical data

Installation
Detailed Installation procedure
Installing the Surge Protection
Install the lightning arrestor on the mast as shown in Figure 2-3. Install
the Surge Protector device and the grounding cable on the backside of
the rack – as shown below. Tighten well using M8 screw.
Figure 2-6: Installation of Lightening Arrestor on Mast
Connecting the N-type to TNC adaptor
Connect the TNC to N-type adaptor (part of the kit) on the “surge” side –
if the lightning arrestor has N-type connectors. If not the cable should
be connected directly without any adaptor.
GPS Timing Receiver Installation and Operation Manual
2-11