MID-DRIVE {Center Mounted Mechanism} Positioning the VCR mechanism in the irenic of the VCR balances ihe VCR's weight 10 improve structural dynamics, In addition, a newly developed 3-point support system and vibration-resistant, lightweight, honeycomb-pans chassis reduce the effects of vibration from both external and internal sources. The innovative new Center Mounted Mechanism produces even higher quality picture.
OPERATE bunion {turns VCR nonfood) I Lock display will work regardless of this button.
REMOTE CONTROL s remote control lets you operate your VCR at a stance. Just aim the front of the cremate control at photo receptor window situated on the front panel your VCR and press the control buttons as you uid on your VCR, resting the Batteries The remote control operates on iwo Ré AA) 1.5 volt batteries (included). If the remote control does not operate or fails to function norm Y, use nsw batteries, which can be purchased at electronics or camera stores. Battery Cover Open the battery cover.
Press the CLOCK button "24H" disappears, and “0:00" starts flashing. You can set the present time using either the @ and © buttons or the numeric buttons (010 9). I you press the @ or © button, the ‘minute’ digits begin 1o change. Astound continue pressing, the ‘minute’ digits wi stop changing (after “00” has been displayed twice) and ihe ‘hour’ a% s only will begin to change. First set the ‘hair’ digits, and then the ‘minute’ digits.
channel Skip here are channel positions that are not preset, you can skip them by the lowing procedure. ‘ample: Skip Channel Position 12 Select the video channel on our TV. Press the OPERATE mutton to turn on the VCR. Select the channel position number you want to sl by pressing the CHANNEL up/ down buttons. (Select channel 12)) Press the GH SET button to select the channel setting mode. Press the GLARE button on the remote control. The channel position number starts flashing.
video Search the following procedure to quickly find the section you want, while viewing 3 picture. During playback, press the FF mutton for forward video search, or the REW butter for reverse search. Reverse Video Search Forward Video Search Press the PLAY button to resume normal playback. JETS: “here is no sand during video search, Luring video search of & tape recorded in the LP mode, the upper part of the picture nay he skewed 10 one side.
RECORDING A TV PROGRAMMER cassette Erase Protection ERASURE PROTECTION TAB § cassettes have a removable tab to prevent “dental erasure of recorded material. Removing 3 tab prevents recording. To retard on a video tsetse with the tab removed, place adhesive 18 over the tab opening. scoring a TV Programmer [VCR Display] Turn on your TV and select the video channel. Press the OPERATE button to turn on the VOR, and then press the DISPLAY button to display [ TOTAL RECORDING TIME ] the channel indicator.
Press the PRIG bunion. The start time display disappears and the stop (finish) time display starts flashing. Set the stop time using the @ or @ button or numeric buttons the same way as described in step @. (Set 1o “10:30") Press the PRIG button. *10:30" disappears, and the channel position number to be recorded sitars flashing. Set the channel number using the @ or © button or numeric buttons (if the channel number Is a single digit, first enter 0).
LINEAR TAPE COUNTER 3¢ movement can be confirmed in hours, minutes and seconds with the 5ii display. Changing of the display and counter clearing are operated by the note cont chunter Display Press ine OPERATE button to turn on the VCR. {The mode indicator is displayed and the channel cation appears after a few seconds, Press the DISPLAY button on the remote control. (The mode indicator is displayed.) Press the DISPLAY button again. (The tape counter is displayed.) Press the DISPLAY button again.
BEFORE CALLING FOR SERVICE » following problems do not always donate a broken VCR. wherefore, perform the checks described below before calling for service. Problem Suggested Solution Problem Suggested Solution o power, LED indicator ions not light. ‘ape cannot be ejected.