Specifications

2.6 COLOR DEVELOPMENT UNIT INSTALLATION (OPTION)
NOTE: The two tapping screws (M4 x6) are enclosed as accessories.
1. Screw the tapping screws [A] into the holes at the rear side of the
development unit as shown. Refer to the following table to determine the
correct combination of screws for each color.
Red Green Blue
Screw Hole [B] Set Not Set Set
Screw Hole [C] Not Set Set Set
[D]
[F]
[E]
[G]
[H]
[C] [B]
[A]
[D]
1 December 1990
3-14