Specifications

2.2 SERVICE PROGRAM MODE TABLE
* Copies can be made. (Refer to NOTE 1.)
Mode No. Function Data Factory
Setting
Comments
*5: Exposure
Lamp OFF
Exposure lamp OFF
Turn on DIP switch
101-1, then press
the Start key to
start free run.
Press the C/S key
to stop free run.
Press the Enter
key in Ready mode
to turn off this
mode.
Use this mode for
the scanner
movement check.
To conserve toner,
remove the
development unit
and disconnect
CN123 on the main
board before
turning on the main
switch.
*6: Jam Detection
Off
Copies are made
without jam
detection.
Press the Start key
to make a copy.
Press the Enter
key in Ready mode
to turn off this
mode.
Use this mode to
check whether the
paper jam was
caused by a jam
sensor malfunction.
The copy counter
increments when
copies are made in
this mode.
8: Input Check Displays the input
from sensors and
switches.
See comments For data, see page
4-22.
9: Output Check Electrical
components turns
on.
See comments For data, see page
4-23.
10: Color
Developer
Initial Setting
Used to set the
new color
developer condition.
Initial setting is
required when
new developer is
installed.
After color
developer
conditioning (20
cycles) is
completed, the
copier
automatically
returns to normal
mode.
*11: All Indicators
ON
Turns on all the
indicators on the
operation panel
To turn off the
indicators, press
the Enter key.
1 December 1990
4-11