Specifications

2.2 1ST MIRROR REMOVAL
1. Turn off the main switch.
2. Remove the exposure glass. (See Exposure Glass Removal.)
3. Move the first scanner to the cutout position (150 mm from the left scale).
4. Remove the reflector cover [A] (2 screws).
5. Remove the sub-reflector cover [B] (2 screws).
6. With your thumb, press down on the 1st scanner as shown to hold it in
place. Then, while holding down the scanner, press up on the front spring
plate [C] with another finger and remove the plate with a pair of pliers.
Leave the rear spring plate [D] in position in the rear side plate cutout.
7. Carefully slide the 1st mirror [E] towards the front of the machine and lift
the mirror out of the machine rear side first.
[A]
[B]
[C]
[A]
[E]
[D]
1 December 1990
5-6