Specifications

2.5 EXPOSURE LAMP REPLACEMENT
NOTE: Do not touch the reflector or the new exposure lamp with your bare
hands. Use a strip of paper as shown. (Oil marks from fingers on the
lamp or reflectors will be affected by heat from the lamp and will
cause discoloration.)
1. Turn off the main switch.
2. Remove the exposure glass. (See Exposure Glass Removal.)
3. Move the first scanner to the cutout position at the rear frame [A]. (See il-
lustration.)
4. Remove the reflector cover [B] (2 screws).
5. Disconnect the exposure lamp wires [C] [D] (1 terminal and 1 connector).
6. Press the release lever [E] on the front terminal while pressing the insula-
tor [F] of the lamp as shown.
[E]
[D]
[C]
[A]
[F]
[B]
1 December 1990
5-11