Specifications

2.7 SCANNER DRIVE WIRE REPLACEMENT
2.7.1 Wire Removal
1. Remove the following covers and parts.
Sorter (if installed) Document feeder (if installed)
Front cover Development unit
Left and right inner covers Left lower cover
Left upper cover Rear cover
Right cover Upper cover
Operation panel Exposure glass
TC/SC power pack
2. Loosen the screws securing the front and rear first scanner wire clamps
[A].
3. Remove the front and rear wire tightened springs [B].
4. Loosen the screws securing the front and rear wire fixing plates [C].
5. Remove scanner wires [D] and [E] from the drive pulley.
6. Remove scanner wire [F] from the left side plate.
7. Remove scanner wire from the drive pulley [G].
8. Remove the drive pulley.
[C]
[F]
[D]
[E]
[B]
[G]
[A]
1 December 1990
5-14