Specifications

2.7.2 Wire Installation
1. Position the scanner drive pulley as shown with the Allen screws facing
you.
2. Put the bead at the end of the blue wire [1] in slot [A] (opposite from the
Allen screws).
3. Put the bead of the silver wire [2] in slot [B] on the Allen screw side.
4. Wind the blue wire [1] clockwise halfway around the pulley. Wind the sil-
ver wire [2] clockwise one complete turn around the pulley.
5. Wind the blue and silver wires together five and a half times around the
pulley. Make sure that the blue wire is wound six times and the silver wire
is wound six and a half times in total.
6. Set the omega clamp [C] over the wires on the drive pulley as shown.
[1]
[A]
[B]
[2]
[C]
[1]
[2]
[3]
[4]
1 December 1990
5-15