Specifications

21. Adjust the tension in the second scanner wire.
(1) Insert positioning pin [A] in the hole at the front end of the second
scanner.
(2) Loosely insert positioning pin [B] in the hole at the rear end of the
second scanner.
(3) Loosen the two screws securing the wire tension bracket [C], then
turn the 2nd scanner positioning screw [D] clockwise until the rear
positioning pin drops and locks in position.
(4) Tighten the two screws securing the wire tension bracket [C].
(5) Make sure the positioning pin [B] slides in and out smoothly. If not,
repeat step (3).
(6) Tighten the screws securing the front and rear wire fixing plates [E].
[A]
[B]
[D]
[C]
[E]
1 December 1990
5-19