Specifications

5.2 1ST PAPER END SENSOR AND PAPER LIFT SENSOR
REPLACEMENT
1. Turn off the main switch.
2. Remove the manual feed table. (See Manual Feed Table Removal.)
3. Remove the paper feed lower guide bracket [A] (2 screws).
4. Remove the paper feed upper guide bracket [B] (1 screw).
5. Remove the 1st paper end sensor bracket [C] (1 screw).
6. Replace the 1st paper end sensor [D] (1 connector).
7. Remove the paper lift sensor bracket [E] (1 screw).
8. Replace the paper lift sensor [F] (1 connector).
NOTE: When installing the paper feed upper guide plate, make sure that the
hooks [G] fit into the holes as shown.
[A]
[B]
[G]
[F]
[E]
[D]
[C]
1 December 1990
5-44