Specifications

5.3 1ST FEED ROLLER, PICK-UP ROLLER, AND REVERSE
ROLLER REPLACEMENT
1. Turn off the main switch.
2. Open the manual feed table.
3. Remove the screw [A] securing the paper lift sensor bracket [B].
4. Close the manual feed table.
5. Slide the sensor bracket in the direction of the arrow.
6. Replace the pick-up roller [C] (1 small snap-ring).
7. Replace the feed roller [D] (1 snap-ring).
8. Remove the paper feed lower guide bracket [E] (2 screws).
9. Replace the reverse roller [F] (1 small snap-ring).
NOTE: a) Snap-rings come in two sizes; the larger of the two is used on the
feed roller.
b) Flat faces [G] and [H] of the feed roller and shaft must be aligned.
[H]
[G]
[B]
[A]
[F]
[D]
[C]
[E]
1 December 1990
5-45