Specifications

- To install (Lower Registration Roller) -
1. Set the ends of the lower registration roller shaft into the front and rear
bushing holes [A].
2. Install the lower guide plate [B] with the front and rear hooks [C] in the
holes.
3. Insert the bushings, set the E-rings and tighten the screw [D] securing the
lower guide plate.
4. Install the spring [E] on the upper guide plate and set the upper guide
plate [F].
5. Hook the spring [E] to the lower guide plate using a paper clip as shown.
NOTE: Make sure of the following when installing the upper registration
roller:
a) The front and rear bushings are different. Make sure that they are
in the correct position.
b) The pressure springs are positioned correctly in the bushings.
[A]
[D]
[C]
[F]
[E]
[B]
[C]
[A]
[E]
1 December 1990
5-60