Specifications

6.3 ERASE LAMP REPLACEMENT
1. Open the front cover and lower the transport unit.
2. Remove the following parts:
• Development unit
• Cleaning unit
• Charge corona unit
• Drum unit
• Rear cover
3. Remove the TC/SC power pack [A] (2 screws, locking supports, and con-
nectors).
4. Disconnect the connector [B] (CN109) from the main board [C].
5. Remove the erase lamp [D] (1 screw).
NOTE: a) Do not use alcohol to clean the erase lamp. This damages the
resin surface of he LED cover.
b) When reinstalling the erase lamp, make sure that the positioning
pin [E] on the lamp fits through the cutout [F] in the front side plate
as shown.
[A]
[B]
[D]
[C]
[F]
[E]
1 December 1990
5-63