Specifications

7. FUSING
7.1 EXIT UNIT REMOVAL
1. Remove the copy receiving tray or slide the sorter in the left side if it is in-
stalled.
2. Open the exit unit [A].
3. Remove the exit unit (2 screws and the rear holder [B]).
NOTE: When reinstalling the exit unit, make sure of the following:
a) The slot [C] in the rear holder fits over the projection [D] on the
fusing unit rear frame and the holder pin [E] fits through the hole
[F] as shown.
b) The projection [G] on the front holder fits through the hole [H] in
the fusing unit front frame.
[F]
[G]
[H]
[D]
[C]
[E]
[B]
[A]
1 December 1990
5-79