Specifications

7.2 FUSING LAMP REPLACEMENT
1. Make sure that the main switch is turned off and the power supply cord is
unplugged.
2. Open and remove the front cover.
3. Remove the left inner cover. (See Interior Covers Removal.)
4. Disconnect the connector [A] at the front side.
5. Remove the front support bracket [B] (1 screw).
6. Remove the rear cover.
7. Remove the ac drive board [C] (all connectors, 4 locking supports, and 1
screw).
8. Pull the fusing lamp [D] out the front end of the fusing roller.
NOTE: a) Do not touch the fusing lamp with bare hands.
b) Slide the new fusing lamp [E] into the fusing roller through the
opening at the rear of the roller. (See the arrow in the illustration.)
c) The connector housings used at the front and rear sides are
different.
d) Make sure that the fusing lamp insulators [F] are properly set in
the holders as shown.
[F]
[D]
[C]
[E]
[F]
[B]
[A]
1 December 1990
5-80