Specifications

7.3 PRESSURE ROLLER REPLACEMENT
1. Remove the exit unit. (See Exit Unit Removal.)
2. If the duplex tray is installed, remove the turn guide plate [A] (2 screws).
If not, remove the fusing bottom plate [B] (2 screws).
3. Remove the exit paper guide [C] (1 screw).
4. Remove the rear cover and the ac drive board. (See Fusing Lamp Re-
placement.)
5. Remove the front and rear pressure springs [D].
6. Replace the pressure roller [E] (2 bushings and E-rings).
[A]
[B]
[C]
[E]
[D]
[D]
1 December 1990
5-81