Specifications

7.4 HOT ROLLER REPLACEMENT
1. Remove the exit unit. (See Exit Unit Removal.)
2. Remove the fusing lamp. (See Fusing Lamp Replacement.)
3. If the duplex tray is installed, remove the turn guide plate (2 screws).
If not, remove the fusing bottom plate (2 screws).
4. Remove the exit paper guide (1 screw).
5. Remove the front and rear pressure springs [A].
6. Remove the C-ring [B] (front side).
7. Remove the bearing stopper [C] (1 screw), and remove the bearing [D]
and spacer [E].
8. Remove the rear C-ring [F].
9. Slide the hot roller out. The gear [G] will drop off the hot roller shaft.
10. Replace the hot roller (1 bearing [H]).
[A]
[F]
[E]
[D]
[B]
[G]
[C]
[A]
[H]
1 December 1990
5-83