Specifications
8. OTHERS
8.1 OPERATION PANEL REMOVAL
1. Open the front cover and remove the following covers:
• Right and left inner covers
• Right Cover
• Rear Cover
2. Disconnect the connectors from the main board (CN130 and CN131).
3. Remove the operation panel [A] (4 screws).
4. Remove the brackets [B] from the old operation panel and install them on
the new operation panel.
5. Install the new operation panel on the machine.
NOTE:
The screws [⊗] are tapping screws. Do not tighten them too much as
this will strip the resin threads.
[A]
[⊗]
[B]
[⊗]
1 December 1990
5-88