Specifications

1.16 PAPER MISFEED
- Phenomenon -
1. Misfeed location indicator turns on when the main switch is turned on
even if there is no paper in the copier.
2. Misfeed location indicator always turns on at the same location when
copies are made.
- Possible Causes -
1. Sensor is defective.
2. Mechanical and/or electrical malfunction
- Action 1 (Initial Misfeed) -
Check which sensor is defective using the Initial Misfeed Table. (See page
4-33.) Replace the defective sensor. If no sensors are defective, replace
the main board.
- Action 2 (Misfeed during copy cycle) -
Set jam Detection OFF mode (SP mode #6) to on and make a copy to see
whether a misfeed occurs.
Misfeed No misfeed
Check which sensor is defective using the Misfeed During Copy
Cycle table. (See page 4-33.) If no sensors are not defective,
replace the main board.
Check whether a mechanical or electrical malfunction occurs. Replace the
defective parts.
1 December 1990
6-22