Specifications

13.1.3 Pick-up Roller Replacement*
1. Turn off the main switch.
2. Remove the feed-in unit. (See Feed-in Unit Removal.)
3. Remove the lower entrance guide [A] (2 screws).
4. Remove the original set sensor assembly [B] (1 screw, 1 connector).
5. Remove the pick-up roller [C] (3 E-rings, 1 bushing, 1 gear).
NOTE: a) Be careful not to loose the pin [D].
b) When installing the roller, make sure the positioning pin is
correctly inserted in the cut-out of the roller.
c) When installing the gear, make sure the flat side of the gear is
facing away from the roller.
[A]
[B]
[C]
[D]
1 December 1990
8-35