Specifications

4. If the difference is more than 2.5 mm, remove the DF main PCB cover (1
screw) and adjust VR102 on the DF main PCB until the leading edge reg-
istration is within specification.
NOTE: Turning VR102 clockwise results in stopping the original later.
5. Using the DF test chart, make a copy in the DF two sided-original mode.
(Insert the original face down.)
6. Compare the leading edge registration with that of the platen cover mode
copy, and check that the difference between the two copies is within 2.00
mm.
7. If out of specification, adjust VR103 on the DF main PCB until the leading
edge registration is correct.
NOTE: a) The test sheet stops pressed against the left scale in DF
two-sided original mode.
b) Turning VR103 clockwise results in the original stopping later.
1 December 1990
8-45