Specifications

11. ROLLER DRIVE BELT REPLACEMENT
1. Remove the front covers [A] (5 screws) and rear cover [B] (2 screws).
2. Lift off the top cover [C] and remove the top stay [D].
NOTE: Be sure that the discharge brush on the top stay is facing the exit
side of the sorter when reinstalling it.
3. Lift the upper paper guide [E] up and out of position.
4. Lift the lower paper guide [F] out of position and turn it over to remove the
roller drive belt [G].
NOTE: Be careful not to damage the sorter home position switch actuator
[H] when reassembling.
5. Remove transfer wheel [I], spacer [J], pin [K] and bushing [L] (1 C-ring).
6. Slide the wheel shaft [M] towards the front and remove the roller drive belt.
[C]
[H]
[E]
[F]
[B]
[D]
[A]
[J]
[I]
[G]
[K]
[L]
[M]
1 December 1990
9-17