Specifications

14.2 INSTALLATION PROCEDURE
14.2.1 Introduction:
This section covers only those parts of the copier and option installation
procedures that differ from the A048.
The following table shows which options can be used on the A048 and A054
copiers:
A048 Copier A054 Copier
Document Feeder (A465) (A318)
NOTE (1)
(A318)
Sorter (A490) (A490)
Duplex Unit (A491) (A491)
NOTE (2)
Color Development Unit (A313) (A313)
DC Power Supply Unit (A494) NOTE (3)
( ) : Product Code
NOTE: (1) The A465 DF can be installed on the A054 copier; however, the
A465 DF does not have a DF positioning sensor, so APS mode
will not function in platen mode.
(2) A054 copiers with the destination codes A054-26, -27 -46, and
-47 are equipped with a duplex unit as a standard feature.
(3) The dc power supply unit for the document feeder and duplex
unit and the interface board are already installed on the A054
copier at the factory. The optional dc power supply unit (Unit
code #A494) is not required.
(4) The installation procedures of the following options are the same
as those of the A048 copier. Refer to each section of the A048
copier as follows:
1. Key Counter Holder Refer to page 3-12.
2. Optics Anti-condensation Heater Refer to page 3-13.
3. Color Development Unit Refer to page 3-14 to16.
1 December 1990
11-33