Specifications

14.3.2 Installation Procedure
1. Remove the following parts from the copier:
1) Platen Cover [A] (2 push-locks)
2) Platen Cover Pedestal [B] (4 screws)
3) The 2 screws [C] securing the operation panel
4) Rear Cover [D] (7 screws).
2. Remove the harness caps [E] on the rear cover with a pair of nippers.
3. Remove the platen cover position sensor [F] (1 screw).
4. Remove the CC/G/B power pack [G] (1 screw and 2 locking supports)
and clamp the connector [H] as shown in the illustration; then, reinstall
the CC/G/B power pack.
[E]
[D]
[A]
[B]
[C]
[H]
[G]
[F]
1 December 1990
11-36