Specifications

15. 3RD PAPER FEED CLUTCH SOLENOID
REPLACEMENT
1. Turn off the main switch.
2. Remove the rear cover (7 screws).
3. Unhook the spring [A] from the tension pulley bracket [B].
4. Remove the drive belt [C] from the drive pulley [D]; then remove the
pulley (1 E-ring).
5. Re move the 3rd paper feed clutch solenoid bracket [E] (2 E-rings and
bushings and 3 screws).
6. Replace the 3rd paper feed clutch solenoid [F] (1 connector).
NOTE: 1. When the clutch solenoid is installed, make sure that the stopper
[G] on the bracket fits into the slot on the clutch solenoid as
shown.
2. When the drive belt is installed, make sure that the belt stoppers
[H] of the drive pulleys are positioned correctly as shown. This is
to prevent the drive belt from coming off the pulleys.
1 December 1990
11-39