Specifications

Rii

Adjusting the Video Channel

To view the output of your VCR on the television screen, you must select an unused channel on your TV and

tune it to the output of your VCR (factory preset to UHF channel 37).

Turn on the TV, select the AV channel or an unused channel on the TV, and turn on the power on the VCR.

(See page 5, item 3.)

@ Load a prerecorded tape into the VCR (not supplied).

@ If the erasure protection tab on the tape is removed, the VCR will automatically play back the tape.

Otherwise press PLAY/x 2.

@ Tune the selected channel on the TV until the picture from the VCR is displayed on the TV screen. (This TV

channel must be selected each time the VCR is used.)

l If picture interference appears on the TV screen in step

above, you can change the video channel (RF

output channel from the VCR)

with

the following procedure. (If UHF channel 37 is an active broadcast channel in

your area, manually select a different channel (UHF 28 to UHF 69) (see below) and then retune your TV as

above.)

(A) Press STANDBY (LOW POWER) on the VCR, or VCR STANDBY (for VCH690X) or STANDBY (for

VC-

H670X)

on the remote control. The VCR enters POWER STANDBY mode. (See page 5, item 2.)

(B) Keep pressing MENU for more than two seconds to light up the

ii-13,,11:0r

on the VCR display. (“VCR” is

displayed above

H-$‘<RF.)

CH~/CHA

dn’the VCR or

A/v

button of

a’-

channel for use as the video channel, then press

SET.

on the remote control to manually select an unused

(D) Repeat steps

to @ above using the newly selected video channel.

(A)

(6)

(Cl