Installation Guide

INSTALLATION
Protect oors when moving heavy objects to prevent permanent scratches and tears. The use of Ram Board or equivalent and cardboard are examples
of protective barriers.
Use appropriate wide oor protectors under tables, chairs, and any other heavy home furnishing to avoid permanent damage. As a rule, the heavier the
object, the wider the oor protector.
Walk-off mats should be used at all entrances to absorb soil and moisture. The use of appropriate mats will help avoid scratches and damages to the
oor. If mats are placed directly on top of the hardwood oors, use proper indoor mats. Mats that can trap moisture underneath have potential to cause
possible discoloration. Latex and rubber backings should not be used.
Area rugs are recommended in high trafc and pivot areas. Avoid shoes with spiked or damaged heels. Also keep pets’ paws and nails cleaned and
trimmed.
Routine Maintenance
Daily removal of dirt and dust is important to prevent particles from abrading the oor’s surface. Sweeping, dust mopping, and vacuuming are
recommendations to remove soil particles that can result in scratches and worn appearances. Do not use vacuums with rotating beater bars on hard
surfaces.
Shaw’s R2x Hard Surfaces Flooring Cleaner and Shaw’s EPA/Dfe Green Formula Hard Surfaces Flooring Cleaner are recommended for general spotting
and cleaning.
Periodic cleaning will be necessary to help maintain the oor’s appearance. Always pre-vacuum or dust mop before any type of cleaning. Shaw’s Hard
Surface cleaner or appropriate hardwood oor cleaning agents (neutral pH cleaners) are recommended.
Do not use abrasive cleaners or cleaning agents that leave dull residues on the surface of the oors. Never wet mop the oor with water and do not
allow excess cleaner to remain on the oor’s surface as this may permanently damage the wood.
Steam cleaners are not recommended.
It is recommended to use a at microber damp mop pad when mopping the oor using a neutral pH cleaner, such as Shaw Hard Surface Cleaner or
Bona Wood Floor Cleaner. Do not use a mop and bucket system.
Expedite drying with air movers or fans.
Do not use oil soaps, liquid or paste wax products, or cleaners with citrus type oils, Tung oils, silicon or ammoniated products as well as 2 in 1 cleaners
with polish additives. Problems from these type products can affect the oor which would not be considered in the warranty.
Spot and Spill Removal
Remove wet spills promptly by blotting with white paper or cloth towels.
Dried spots should be removed by Shaw’s R2x Hard Surface cleaner with gentle agitation from a clean towel or cloth. Always blot dry.
Do not use detergents or abrasive cleaners since these products can result in a dull residue and appearance.
Use rubbing alcohol (isopropyl alcohol) with a clean white cloth for spots requiring a solvent type cleaner that hardwood cleaning agents cannot
remove.
Please note that some stain conditions may become permanent.
9
shawoors.com
For reference purposes only if printed or downloaded. Revision: 12032019