User's Manual

iSmartTool Series User Manual

2 Initial Use

2.1 Charging & Turning On

1. Plug one end of the included USB cable into the USB Type C port of the tool,

and the other end to the DC external power adaptor.

2. Plug the other end of the power adaptor to the AC outlet to start charging.

3. Press the POWER button to turn the tool on.

Caution: Please use the included power adaptor to charge your tool. No

responsibility can be assumed for any damage or loss caused as a result of using power

adaptors other than the one supplied.

Note: If the battery remains unused for a long period of time or the battery is

completely discharged, it is normal that the tool will not power on while being charged.

Please charge it for a period of 5 minutes and then turn it on.

2.2 Printer Setting

The tool has a built-in printer available for printing reports or screenshots. The

printer applies thermal paper roll with size of Φ30×57mm. Follow the steps

described as below to load it.

1. Dig your finger from the gap and lift it up gently until the printer cover is

opened.

2. Place the unpacked thermal paper into the compartment with its starting end

approaching to the paper outlet. Reversing paper direction will result in that

no results will be printed out.

3. Pull out some printing paper and introduce it along the slot until it comes out

of the paper outlet shown as below. Otherwise, paper can not be fed.